For welding and cutting

Lasersan®

Gas and mixtures for laser cutting and welding.

Competence on laser process

Cutting and welding sheet metal through the laser process requires gases and mixtures of high purity and production precision. Nippon Gases, through decades of experience in the production of gas, and in collaboration with the best manufacturers of laser systems, has developed production techniques capable of meeting the strictest requirements of manufacturers and beyond.

In our product portfolio, we have all the mixtures for laser resonators marketed with purity titles above the minimum requirements required by manufacturers of laser systems.

CO2

CO2 have a responsibility to create light emission for effect of energy excitation, that after polarisation, became laser beam.

The job of this gas is double, into the source accumulate electron to move to CO2 when it needs to maintain excitation itself, in second as protection of metal sheet during the cutting process.

CO2

CO2 have a responsibility to create light emission for effect of energy excitation, that after polarisation, became laser beam.

The job of this gas is double, into the source accumulate electron to move to CO2 when it needs to maintain excitation itself, in second as protection of metal sheet during the cutting process.

Metal reactivity

Every single material requires a
specific root protection gas.

Carbon steel, stainless steel, aluminum, titanium and
many others have metallurgical different characteristics
and a reactivity towards air.

During the laser cutting or welding phases it is essential
to protect or bring heat to allow the process, while the
absence of pollutants allows to exploit all the power of
the laser sources, whether CO2 or fiber.

Pressure control panel

It is equally important to maintain the purity of the gases contained in the containers up to the point of use. In this case too, the experience and passion that distinguishes Nippon Gases have allowed us to design specific equipment for gas management.

Gas distribution systems

To supply gas to a laser cutting system it is essential to know fluid dynamics. In fact, it is essential to guarantee high flow rates at high pressures without affecting the machine with pressure changes.

The laser cutting is constantly evolving and is moving towards high-quality applications, on a wider range of thicknesses and with good economic results, on batch processing with greater quantity of pieces.

Laser cutting

Thanks to the high focusability of the laser beams, it is possible to obtain narrow and parallel cutting edges, a very reduced thermal altered area, limited thermal distortions, ability to operate on complex profiles and with very small radii of curvature (even sharp edges).

In reality, laser cutting produces finished pieces,which do not require other complementarymanipulations (e.g. drilling of holes or other) orfinishing (e.g. sanded or other). In systems usingCO2 sources , the laser beam must be directed tothe focusing lens through mirrors. It is essentialthat no polluting substances (dust, hydrocarbonsetc.) are deposited on these components, which cause a greater absorption of the incident power.

This would not only reduce the laser arriving to the material to be processed, but would also cause variations in the transmission conditions and beam focus.

It is therefore important that the entire optical path, from the source to the focusing element, is hermetically closed, and a protective gas (air or nitrogen) flows in slightly overpressure. This gas must be filtered for dust (diameter <0.1 μm, density <0.1 mg / Nm3) and de-oiled (content <0.01 mg / Nm3).

Many times, the failure to comply with this condition leads to serious problems in terms of reliability of the performance of the system..

Do you still have questions?

In Nippon Gases we have developed various qualities of gases to adapt to your applications. Call us or write to us and we will help you get the most out of it.